LOG

Generated from C.60.01 /SYS/PUB/CICAT last modified on Thu Jan 11 09:18:52 2001

Back to Main Index

LOG

     Starts, restarts, or stops User Logging.

SYNTAX

               {,RESTART}
     LOG logid {,START  }
               {,STOP   }

PARAMETERS

logid               Logging identifier previously established with a
                    user GETLOG command.

START               Initiates a logging process.

RESTART             Restarts a logging process.

STOP                Terminates a logging process.

OPERATION

     This command allows you to start, restart, or stop User
     Logging.  For further discussion of User Logging, refer to
     the Managing User Logging Facilities (32650-90027).

     You may change log files at any time, without the delay
     normally caused by executing a LOG command.  You may instead
     invoke the CHANGELOG command to enable interactive log file
     changing;  you may use the AUTO parameter of the ALTLOG and
     GETLOG commands to enable automatic log file changing.  Refer to
     the commands ALTLOG, CHANGELOG, GETLOG, and SHOWLOGSTATUS.

     This command can be issued only from the console, unless
     it has been distributed to other users with the ALLOW
     command.  It may be issued from a session, job, program,
     or in BREAK.  Pressing [Break] has no effect on this
     command.

EXAMPLE(S)

     To start the logging process identified by logid LOGPROCX enter

     LOG LOGPROCX,START

ADDITIONAL INFORMATION

Commands:   ALTLOG, CHANGELOG, GETLOG, SHOWLOGSTATUS

Manuals :   User Logging Programmer's Guide (32650-90027)

Back to Main Index